Axlon's line was built for one platform. Adding a second meant either a costly parallel line or hours lost to manual changeover between runs. Neither fit their volume targets.

The challenge

Switching tooling, fixtures, and weld paths by hand took most of a shift. Every changeover was a window where quality drifted and output stopped.

What we built

Precept engineered a robotic assembly cell with interchangeable end-of-arm tooling and stored weld programs for both platforms. Changeover became a software call, not a manual rebuild.

The result

Two platforms now run down the same line with changeover measured in minutes. Output rose and warranty claims tied to inconsistent joints fell to near zero.